|
|
 |
Tracy's Third HFS |
 |
Page #7 of 9
"Don't believe anything I say; learn about what I say and prove it to yourself!"
by Tracy Jones
First one shows placing my ribs placed in the lower board. I slotted the board by slicing through the wing and used stop tabs pop riveted into the wing to hold the ribs upright. You can see the small slots I indented into the inside of the ribs to hold the outer rings of magnets in place. The top board is also slotted and will fit down onto the ribs for easy assemble and disassemble. The second one shows the outer rings and first cone in place on the board. I used a one-inch by 1/16 inch aluminum strip to hold the two inch strip of magnets in place. The third one shows the two outer rings assembled. The fourth shows a complete assembly except for the skin and top piece. The very top two magnets attached to a brass rod seated in a shot glass on the bottom wing is being held in suspension by the two large 8 and 1/4 inch magnets.
 |
 |
 |
 |
|
|
|